3D Decoupage card

3D Decoupage card Requirements: Decoupage Print Cutting Mat Craft Knife & Scissors Silicone Glue & Uhu Stic Card Blank Eyelets
Cutting out the Image: To cut out the image use a craft knife and scissors, nail scissors that have a rounded blade are also useful. Start with the intricate cutting and small areas rather than leave them until last, this way you'll have more of the image to hold on to.
Tips on Cutting: Make sure you cut into the corners, don't be tempted to pull the paper, if the cuts do not meet, pulling the paper will leave jagged edges or fraying. Keep the knife upright and not at an angle to avoid white edges. If you do get any white edges simply colour them with felt tip or water colour paint. Always cut away from a corner.
Stick The first layer onto the card using Uhu Stic glue.
The next layers can be stuck with either Silicone glue or sticky pads, however you'll get better results with silicone. Applying Silicone glue Squeeze out a small amount of glue onto a nonabsorbent surface, using a tooth pick or fine tipped embossing tool, roll the end in the glue to pick up a small blob, then apply the glue to the back of the layer.
Adding Shape to layers To add more shape and depth to your finished image, emboss the layers to give them a more rounded effect. Before you apply the last layer, turn it over and place it on a mouse mat, then using the handle of a tea spoon gently emboss the image.
Total time to make this card, around 45 minutes.