Baby Blue Pocketfold Wedding Invitation
To make this wedding invitation you will need the following products
Use an ivory Pocketfold Wedding Invitation and ivory pocketfold postcard -code WP9
Overlay the WP9 with a Glitter Paper WP140 on top of this use an ivory round corner overlay – code R3S0
For the front of the card between the letters ‘Wedding’ use aquamarine Swarovski crystals
Finnish with blue velvet ribbon and a diamante buckle square slider
The approximate cost of this wedding invitation is £2.95
Make this Eye Catching Wedding Invitation for Under £1.00
Use a 6 x 6 wedding initiation card in silkweave linen white, Card Code 36
Mount a length of yellow organza 15 mm ribbon on the right side of the card using 6mm double sided tape
You can now stick a mint green 6mm ribbon satin ribbon in the middle of the yellow ribbon.
Next you will need two daisy craft punches, One 25mm daisy punch and one 15mm daisy punch
Using A4 yellow glitter card, first punch out three small daisies (15mm), then using light green glitter card punch out two large daisies(25mm)
Apply a wet glue such as Stix 2 PVA to the back of the daisies and position them in place on the card.
Then use self adhesive light green 5 mm diamantes and decorate as desired.
To complete your wedding invitation you also need a white 6 x 6 envelope and a smooth white card insert to print your invitation words on to.
Pocketfold Wedding Invitation Project
Products you require to make this pocketfold wedding invitation
WP7 foiled Pocket Wedding Invitation 3.2 white silkweave
Sheer organza ribbon ivory colour
Ivory 6mm satin ribbon
Diamante hearts
Silk Swarvoski crystals
Step 1 – Add the Organza Ribbon
Use kooky kards 6mm double sided tape
Stick the double sided tape on to the front of the pocketfold just above the wording, make sure that you cut the tape a little longer than the card.
Then cut a length of organza ribbon again longer than needed apply this ribbon to the double sided tape,
Ensure that you pull the ribbon tight to ensure it sticks flat and does not rouche up.
If this does happen it is easy enough to un-peel the ribbon and re-stick in the position you want.
When you are happy with the ribbon position, smooth the ribbon with your fingertips to ensure it is well stuck.
Now trim the ends of the ribbon and the double sided tape with sharp scissors.
Step 2 -Add the 6mm Ribbon
Using Kooky Kards 3.5 mm double tape stick a length centrally over the organza ribbon
Take 6mm ivory ribbon and cut a length slightly longer than needed and position onto the double sided tape
Trim both ends of the ribbon as in step one.
Step 3 – Adding the Heart
Use Kooky Kards PVA glue to apply diamante heart
Take a diamante heart, I’ve used a gold backed one for this project and apply the the glue to the back using a cotton bud, place the heart centrally onto the ribbon.
Step 4 – Sticking the Swarovski Crystals
Use Kooky Kards Glue Pen - This product is ideal for small or fiddly gluing projects.
Apply a small amount of glue in between each letter of the word ‘Wedding’, carefully place a Swarovski crystal on each dot of glue using tweezers, leave to set.
Your pocketfold is now complete!
Inside the Pocket Fold
Use WP9 Ivory Limed as the main backing postcard, over this stick a glitter white WP140 then finally a Pearl white Paper Overlay
Use 6mm double sided tape to mount the WP140 and overlay onto the postcard, finally use Velcro Dots on the front flap of the pocketfold so that it can be opened and closed